Guardian Procedure Calls Reference Manual (G06.25+)

Guardian Procedure Calls (S)
Guardian Procedure Calls Reference Manual—522629-013
14-73
SETMODE Procedure
13 Terminal: Set system read termination on ETX character (default is
configured)
param1 = 0 no termination on ETX
= 1 termination on first character after ETX
= 3 termination on second character after ETX
param2 is used, with ATP6100 only, to specify the value of the ETX
character. No changes occur to the read termination on ETX as specified by
param1 if you do not specify an ETX character or if you set param2 to 0
(setting the ETX character to 0 is not allowed).
14 Terminal: Set system read terminal on interrupt characters (default is
configured)
param1.<15> = 0 no termination on interrupt characters (that is,
transparency mode)
= 1 termination on any interrupt character
param2 is not used with function 14.
SETMODEs 15, 16, 17, 18 and 19 are described in the
EnvoyACP/XF Reference Manual.
15 Terminal: Set retry parameters
16 Terminal: Set line parameters
17 Terminal: Set maximum frame size and secondary addresses
18 Terminal: Set statistics threshold, flag fill, and window size
19 Terminal: Set translation parameters and set extended control field size
20 Terminal: Set system echo mode (default is configured)
param1.<15> = 0 system does not echo characters as read.
= 1 system echoes characters as read.
param2 is not used with function 20.
Table 14-4. SETMODE Functions (page 6 of 34)
function Parameters and Effect