Guardian Procedure Calls Reference Manual (G06.25+)

Guardian Procedure Calls (S)
Guardian Procedure Calls Reference Manual—522629-013
14-76
SETMODE Procedure
22,
continued
If you specify split baud rates with the LIU-4 controller, the
last-params
parameter returns the following values:
last-params[0].<0:7>param1 value (TX)
.<8:15>
param2 value (RX)
last-params[1]undefined
23 Terminal: Set character size
param1 = 0 character size = 5 bits
1 character size = 6 bits
2 character size = 7 bits
3 character size = 8 bits
param2 is not used with function 23.
24 Terminal: Set parity generation by system
param1 = 0 parity = odd
1 parity = even
2 parity = none
param2 is not used with function 24.
25 Line printer (subtype 3): Set form length
param1 = length of form in lines
param2 is not used with function 25.
26 Line printer (subtype 3): Set or clear vertical tabs
param1 = 0 is (line#-1) of where tab is to be set.
= -1 clear all tabs (except line 1).
Note: A vertical tab stop always exists at line 1 (top of form).
param2 is not used with function 26.
27 Line printer or terminal: Set system spacing mode
param1.<15> = 0 postspace (default setting)
= 1 prespace
param2 is not used with function 27.
Table 14-4. SETMODE Functions (page 9 of 34)
function Parameters and Effect