Guardian Procedure Errors and Messages Manual

Cause The specified disk volume was physically mounted, but the system has not received a mount
request.
Effect The procedure sets the error code and returns without performing the requested operation.
Recovery Retry the operation after issuing a mount command.
63 (%77) The volume was mounted and the mount is
in progress, so a file open is not
permitted. (device type: 3)
Cause The specified disk volume was physically mounted and the mount command has been given,
but the mount has not finished.
Effect The procedure sets the error code and returns without performing the requested operation.
Recovery Retry after the mount finishes.
64 (%100) The volume was mounted and the mount
is in progress, so a file open is not
permitted. (device type: 3)
Cause A file open operation was tried while a mount operation was in progress.
Effect The procedure sets the error code and returns without performing the requested operation.
Recovery Retry after the mount completes.
65 (%101) Only special requests permitted--or special
request to mirrored disk pair attempted with
only one device in special state.
(device type: 3)
Cause This error can occur for the following reasons:
• A system operator designated the specified disk volume for special request mode.
• A read or write operation with the special bit set was attempted on a mirrored-disk pair that
has one device in the up state, the other device in the special state.
Effect The procedure sets the error code and returns without performing the requested operation.
Recovery Retry after the volume is available for normal operations.
66 (%102) The device is downed, the LIU is not
yet downloaded, a hard failure occurred
on the controller, the disk and controller
are not compatible (DP1/DP2), or both halves
of a mirrored disk are down.
(device type: any except 2)
Cause This error can occur for the following reasons:
• The system operator brought down the specified device.
• A hard error occurred on the device controller.
• A path failure error in the range {210:226} occurred in a network.
• A DP2 disk process discovered a DP1 volume label or other label consistency problem.
• Both halves of a mirrored disk are down.
Effect The procedure sets the error code and returns without performing the requested operation.
If a path failed but other lines are active, the network brings down the defective line.
36 File-System Errors