Guardian Procedure Errors and Messages Manual

Recovery Corrective action is device dependent and application dependent.
231 (%347) Controller power failed, then restored.
(device type: any except 2)
Cause The controller power failed and then was restored during this operation (path error). At least
one path, and possibly both paths, is operable.
Effect The file operation stops at some indeterminate point.
Recovery Corrective action is device dependent and application dependent. Check the log for a
channel reset (operator message 77) which can also cause a file-system error 231 to occur (the
power-on interrupt causes all controllers on the channel bus to be cleared so they can continue
processing).
232 (%350) Access is denied due to error in
communication with SMON.
Cause There is a lack of Safeguard resource to support the request; this is an internal error.
Effect Access is not possible at this time.
Recovery Wait, then try again. The number of retries is limited.
233 (%351) Error in call to SERVERCLASS_SEND_.
Cause An error occurred in a call to SERVERCLASS_SEND_.
Effect The call is not accepted.
Recovery Correct the error in the call and try again.
240 (%360) Network line handler error; operation not started.
EXPAND performed an ownership switch.
(device type: 63)
Cause The Expand process performed an ownership switch.
Effect All traffic not yet sent to the remote system, and traffic that belongs to the affected Expand
process is terminated. The application must not see this error.
Recovery The file system automatically retries. For additional information, see the Expand Network
Management Guide.
241 (%361) Network error; operation not started.
(device type: 63)
Cause The network control process ($NCP) caused the Expand process to terminate its unsent traffic
for one of the following reasons:
• A connection to a remote system was established or reestablished over the same path or a
different path.
• The network control process came up (for example, after a crash or a takeover by the backup).
• There was no longer a path to the remote system (console message 43, LDEV ldev NET:
CONNECTION LOST TO SYS nnn, is generated by the NCP).
Error Code Descriptions 63