Guardian Programming Reference Summary for pTAL and TAL

SETMODE Operations
Guardian Programming Reference Summary for pTAL and TAL—522631-001
11-6
<function> Parameters and Effect
22 Line printer (subtype 3, 4, 6, and 32) or terminal: Set baud rate
param1 =
0 baud rate = 50
1 baud rate = 75
2 baud rate = 110
3 baud rate = 134.5
4 baud rate = 150
5 baud rate = 300
6 baud rate = 600
7 baud rate = 1200
8 baud rate = 1800
9 baud rate = 2000
10 baud rate = 2400
11 baud rate = 3600
12 baud rate = 4800
13 baud rate = 7200
14 baud rate = 9600
15 baud rate = 19200
16 baud rate = 200
17 baud rate = 38400 (5577 printer only)
The param2 parameter is not used with function 22, except when
specifying split baud rates with the LIU-4 controller (see below).
Note:
The 5520 line printer supports only the 110, 150, 300, 600, 1200, 2400, 4800,
and 9600 baud rates.
The 5530 line printer supports only the 75,150, 300, 600, 1200, 2400, 4800,
and 9600 baud rates.
If no baud rate is specified at SYSGEN, then 9600 baud is used. The default
rate is what was specified at SYSGEN.
The asynchronous controller supports only the 150, 300, 600, 1200, and 1800
baud rates.
An ATP6100 line configured on an LIU-4 controller allows an application to
set different transmission (TX) and receiving (RX) baud rates with function 22.
You have the option of setting split rates by specifying the TX rate in param1
and the RX rate in param2. You can set nonsplit rates by the normal method
(that is, by specifying values for param1 as listed at the beginning of the
description of function 22. The LIU-4 does not support 3600 or 38400 baud
rates.)