Guardian Programming Reference Summary for pTAL and TAL

Guardian Programming Reference Summary for pTAL and TAL—522631-001
15-1
15
Error Codes
This section contains a list of error codes that are returned by Guardian procedure calls
and the file system. For a full description of the error codes, refer to the Guardian
Procedure Errors and Messages Manual.
File-System Error Codes
Code Description
0 Operation successful
1 End-of-file
2 Operation not allowed on this type of file
3 Failure to open or purge a partition
4 Failure to open an alternate key file
5 Failure to provide sequential buffering
6 System message received
7 Process not accepting control or setmode
8 Operation successful (examine MCW for additional status)
9 Operation successful, the data returned was locked by another user
10 File/record already exists
11 File not in directory or record not in file, or the specified tape file is not present on
a labeled tape
12 File in use
13 Illegal file-name specification
14 Device does not exist
15 Volume specification supplied does not match name of volume on which file
actually resides
16 File number has not been opened
17 Paired open was specified and the file is not open by the primary process, the
parameters supplied do not match the parameters supplied when the file was
opened by the primary, or the primary process is not alive
18 System does not exist
19 No more devices in logical device table
20 Attempt to open network file with a name either too long or not acceptable
21 Illegal count specified
22 Application parameter or buffer address is out of bounds
23 Disk address is out of bounds
24 Privileged mode required for this operation