Guardian Programming Reference Summary for pTAL and TAL

Error Codes
Guardian Programming Reference Summary for pTAL and TAL—522631-001
15-4
89 Remote device has no buffer available
90 Transaction aborted by system because its parent process died
91 Transaction aborted by system due to database ID inconsistency
92 Distributed transaction aborted by system due to network partition
93 Transaction spanning too many audit files aborted by system
94 Transaction aborted by operator command
95 Transaction aborted because of disk process takeover by BACKUP
96 Transaction aborted because it exceeded the AUTOABORT timeout duration
97 Transaction was aborted
98 Transaction monitor process’s network active transactions table is full
99 Attempt to use microcode option that is not installed
100 Device not ready or controller not operational
101 Tape write protected
102 Paper out, bail open, or end of ribbon
103 Disk not ready due to power failure
104 No response from device
105 Invalid VFU buffer
106 A previously buffered write has failed
110 Only BREAK access permitted
111 Operation aborted because of BREAK
112 READ or WRITEREAD preempted by operator message or too many user
console messages
113 DEFINE attributes not valid for attempted function
114 X.25 network line problem – restart failure
115 X.25 network problem – reset failure
119 Error code value was too large to fit into 8-bit container
120 Data parity error, or attempt to access a tape whose density is higher than the
switch setting on the tape drive
121 Data overrun error
122 Request aborted due to possible data loss caused by reset of circuit, or due to CLB
sequence error or a DP2 disk process takeover
123 Subdevice busy
124 Line reset is in progress
130 Illegal address to disk
131 Write check error from disk
Code Description