Inspect Manual

High-Level Inspect Commands
Inspect Manual—429164-006
6-93
HISTORY
HISTORY
The HISTORY command displays the most recently executed command lines.
num
is the number of commands to display.
Default Value
If no number is specified, the last 10 commands are displayed.
Usage Consideration
The HISTORY command is equivalent to LIST HISTORY -num/-1, except when less
than num command lines are in the history buffer, in which case all lines in the history
buffer are displayed.
Related Commands

FC on page 6-84

LIST HISTORY on page 6-135

XC on page 6-224
HOLD
The HOLD command suspends the execution of a program on the program list, placing
it in the hold state. Inspect does not begin prompting again until all suspensions are
accomplished.
program
specifies a program using one of several formats. program-number identifies the
program by its program number (as shown by the LIST PROGRAM command).
program-name identifies the program by its program name (as shown by the LIST
HISTORY [ num ]
HOLD [ program [ , program ]...]
[ * ]
program: one of
program-number
program-name
cpu,pin
Pathway-term-name