Inspect Manual

High-Level Inspect Commands
Inspect Manual—429164-006
6-138
Related Commands

If no program is specified, or “*” is specified, information is listed about all
programs on the program list.
Related Commands

ADD PROGRAM on page 6-10

HOLD on page 6-93

INFO OBJECTFILE on page 6-111

INFO SAVEFILE on page 6-120

PROGRAM on page 6-156

SELECT PROGRAM on page 6-167

STOP on page 6-215
Output
Use of the DETAIL clause results in the following output format:

Fields labelled with a “*1” are listed only for OSS programs. Fields marked with a
“*2” are listed only for programs that use libraries. A program may use zero or
more libraries.

Fields marked with a “*3” are listed only for TNS/R native programs, which can
have multiple libraries.

The processor will be listed as “unknown” if the program is a save file that was
created prior to C30 or on D00.

The processor will be listed as TNS/E for TNS programs on a TNS/E system.
-PROGRAM-LIST PROGRAM 1, DETAIL
Name: name
Number: number
General Information
CPU,PIN: cpu,pin
[ OSS PID: num ] *1
Guardian Version: tos version
Instruction Set: TNS | TNS/R
Location: current loc
Processor: family (processor)
Program File: filename
[ Libraries: library filename ] *2
[ library filename ] *3
State: HOLD | STOP | GONE | RUN
System: name (number)
Type: TNS [SAVE] | TNS/R [SAVE] | PATHWAY
INSPECT Information
ABEND Breakpoint: YES | NO
Code Breakpoints: integer
Data Breakpoints: integer
Source System: None | name (number)
STOP Breakpoint: YES | NO