Inspect Manual

High-Level Inspect Commands
Inspect Manual—429164-006
6-156
PAUSE

TERM on page 6-218

VOLUME on page 6-223
PAUSE
The PAUSE command suppresses Inspect prompts until a debug event occurs in any
of the programs on the program list.
Usage Considerations

Inspect begins prompting after a PAUSE when:

You press the BREAK key, assuming that the program has not taken control of
the BREAK key.

Any running program under the control of Inspect generates a debug event.
(see the information on debug events and execution states in Section 2,
Inspect Concepts).

Inspect receives a wake-up message from any process. For more information,
see the TACL Programmer’s Guide.

Using PAUSE to Share the Inspect Command Terminal
If Inspect and the program you are debugging share the same terminal, you can
use the PAUSE command to return control of the terminal to your program.
PROGRAM
The PROGRAM command displays the programs in the program list or selects a
program as the current program.
program
specifies a program using one of several formats. Program-number identifies a
program by its program number (as shown by the LIST PROGRAM command).
PAUSE
PROGRAM[S] [ program [ CODE code-file ]
[ LIB lib-file ]
[ SRL {(srl-file [ , srl-file,...])}]
program: one of
program-number
program-name
cpu,pin