Inspect Manual

High-Level Inspect Commands
Inspect Manual—429164-006
6-190
Default Values
PROGRAM PID
directs Inspect to display the current program’s process ID in the form sys,cpu,pin.
SCOPE
directs Inspect to display the current scope path.
STATE
directs Inspect to display the current program's execution state: RUN, HOLD,
STOP or GONE.
For more information about execution states, see Section 2, Inspect Concepts.
SYSTYPE
directs Inspect to display the current systype, either Guardian or OSS.
TYPE
directs Inspect to display the current program’s type.
For more information, see Scope Paths on page 2-12.
Default Values

If you omit level, SET STATUS LINE25 and SET STATUS SCROLL affect the
current command mode.

If you do not specify a list of status items, Inspect sets the specified status
message (line 25 or scrolling) to nothing.

The default INSPLOCL file sets the scrolling and line 25 portions of the event-
status message as follows (note that it sets the line 25 portion to display nothing):
Usage Considerations for SET STATUS LINE25

When Inspect Updates Line 25
Inspect updates the line 25 status message when a debug event occurs. In
addition, Inspect updates the line 25 status message when the value of one of its
status items changes. For example, if you set the line 25 status message to
include the current language, Inspect will update the line 25 status message
whenever the current language changes.
SET STATUS SCROLL BOTH = "INSPECT ",EVENT,NEW LINE,PROGRAM PID," ", &
PROGRAM NAME," ",LOCATION
SET STATUS LINE25 BOTH