Inspect Manual

High-Level Inspect Commands
Inspect Manual—429164-006
6-217
SYSTEM
is used to terminate the second process. Inspect automatically prompts for commands
for the earlier process:
SYSTEM
The SYSTEM command sets the default system for expanding file names as operands
to Inspect commands.
system
is an HP NonStop system name. A system name always begins with a backslash
and has one to seven additional alphanumeric characters; the first character after
the backslash must be alphabetic.
Default Value
If you omit system, Inspect sets the default system to the host system of the Inspect
command terminal.
Usage Consideration
Inspect does not use the default system name you set using the SYSTEM command to
expand names of source files. To change the default system name for source files,
use the SELECT SOURCE SYSTEM command.
Related Commands

ENV on page 6-81

VOLUME on page 6-223
_$UT_HIGH
-$UT-COMMENT Press BREAK key and pause to start second process
-$UT-{ BREAK key pressed }
5>RUND OBJECT /NAME $UT2/
-$UT-PAUSE
:
:
-$UT2-COMMENT stopping $UT2 gives prompt for remaining $UT
-$UT2-STOP
-$UT- COMMENT pause or press BREAK key to start another process
SYSTEM [ \system ]