Inspect Manual

Using Inspect on a TNS/E System
Inspect Manual—429164-006
18-5
Debugger Selection on TNS/E Systems
Debugger Selection Criteria
In the flowcharts shown in both Figure 18-2 on page 18-6, and Figure 18-3 on
page 18-7, debugger selection criteria are defined:
Criteria Meaning
INSPECT attribute on? The setting for the INSPECT attribute is set ON for the
process you will debug (set with TACL, the compiler, or
the linker).
Visual Inspect session? You have started Visual Inspect and have connected to
the NonStop host on which the process to be debugged
will run. The user ID of the process must match the user
ID that was used to log on to Visual Inspect.
Inspect available? The Inspect subsystem (IMON, DMON, $DMnn) is
running, and the Inspect command-line interface is
available.