Inspect Manual

Error and Warning Messages
Inspect Manual—429164-006
A-2
2
2
While scanning for the remainder of a continuation line, a line following a line ending
with a “&,” Inspect encountered the end-of-file. This generally occurs only when
Inspect is reading commands from INSPLOCL, INSPCSTM, or an OBEY file.
However, Inspect also generates this message if you press CTRL/Y when entering a
continuation line.
3
This is a warning. You attempted to display registers in a program while in the
STOP/ABEND state.
4
The command list exceeded 512 characters after Inspect expanded any aliases it
contained.
5
The command list specified an invalid integer.
6
A string specified in the command list is missing its closing delimiter (apostrophe or
quotation mark).
7
The command list included an identifier longer than the Inspect maximum of 31
characters.
Unterminated continuation line
Registers R0-R7 and E are not valid in the STOP state
Effective input record is too long
Integer conversion error
Unterminated string
Identifier too long