Inspect Manual

Error and Warning Messages
Inspect Manual—429164-006
A-3
8
8
The given file name does not conform to syntax conventions.
9
A volume or subvolume name specified in the command list is too long (longer than
eight characters), contains an invalid character, or specifies a volume that does not
exist.
10
A system name specified in the command list is too long, contains an invalid character,
or specifies a system that does not exist.
11
A number specified in the command exceeds the allowed range. For example, there is
a well-defined limit for an input value used with a TEMP clause, bit-field or segment ID.
12
The OBEY command would cause nesting of OBEY commands beyond four levels,
which is the maximum Inspect supports.
13
This is a warning. You attempted to display registers in a program while in the STOP
state.
Invalid file name file-name
Invalid Subvolume name
Invalid System name
Numeric range exceeded
OBEY nesting exceeds maximum
Registers are not valid in the STOP state