Inspect Manual

Error and Warning Messages
Inspect Manual—429164-006
A-8
41
41
The process specified for debugging does not have the Inspect attribute set.
42
The BREAK command specified the BACKUP clause, and the CPU executing the
backup process has no active DMON process. Contact your system manager or
system operator.
43
The BREAK command included the BACKUP option, but the current program has no
backup process.
44
The command specified requires an active program.
45
The requested operation is not valid on the current program, possibly due to the type of
the program or its state.
46
Inspect cannot create the specified breakpoint because the breakpoint table for the
CPU or TCP executing the current program is full. For CPUs, the maximum number of
breakpoints is set at system generation. For TCPs, the maximum number of
breakpoints is 20.
Inspect not enabled for process
Required DMON not active
No backup process active
No active program
Invalid request
Breakpoint table full