Inspect Manual

Error and Warning Messages
Inspect Manual—429164-006
A-20
117
117
A warning. A line number specified as a code-location or data-location in a command
had no executable statement associated with it. The next executable statement begins
at line number line-number.
118
Inspect does not recognize the given line number for one of these reasons:
1. It is less than the first line number defined in the scope unit.
2. It is greater than the last line number defined in the scope unit.
3. It is in a source file other than the one containing the declaration of the scope unit.
120
Inspect cannot find a source file that you specified in the command list either as part of
a code location or as the parameter to DELETE SOURCE OPEN.
121
Inspect has encountered a trap at the given location; a stack trace usually follows this
message. Contact your Tandem representative.
122
For multiple code segment programs in low-level Inspect, you must indicate the code
segment in addition to the address for the scope unit. If the scope unit is not in the
code segment you specified, Inspect displays this error.
A subsequent line number is assumed: line-number
Line number is not recognized, try specifying source file
also: line-number
Source file is not recognized: file-name
Fatal Trap trap-number AT P = %nnnnnn IN space-id
Specified proc refers to a different code segment: space-id