Inspect Manual

Error and Warning Messages
Inspect Manual—429164-006
A-22
128
128
In low-level Inspect, a display command using the table format exceeded the maximum
table size for the Inspect message buffer. Inspect truncated the table to the maximum
size.
129
The symbols cannot be accessed because Inspect detected an inconsistency in the
Inspect region of the object file. The object file was compiled with a compiler from a
release that is more recent than the release of the Inspect you are using (for example,
a C10 compiler and a C00 version of Inspect). Inspect defaults to the low-level mode
for this session. Use Inspect from the same release as the compiler used to compile
the object file.
130
An attempt was made to display an enumerated type for which the literal
corresponding to its value was not saved. The number of enumerated type literals
stored in older object file versions was limited.
131
Inspect encountered an invalid network volume name in a SOURCE command when a
SOURCE SYSTEM command was in effect. Inspect cannot retrieve the source file
from the remote system.
132
This is a warning. When a program has no active user library and you want to select
that program as the current program, the above warning is displayed.
Maximum table size exceeded. Table size truncated.
New object file format, symbols cannot be accessed.
Following value was too large, INSPECT cannot access
enumeration identifier
Volume name is too long to be used with a system
specification
Program has no active user library; Library file will
be used for static symbol access only