Inspect Manual

Error and Warning Messages

Inspect Manual—429164-006

A-26

174

The original and new names you use in an ADD SOURCE ASSIGN command must

include a volume name.

176

The original name and new name you use in an ADD SOURCE ASSIGN command

must both be qualified to the same level. If the original name is a volume, the new

name must be a volume; if the original name is a subvolume, the new name must be a

subvolume.

177

The original name you provided in a DELETE SOURCE ASSIGN command does not

have a source assignment. Use the LIST SOURCE ASSIGN command to display the

existing source assignments.

183

The value in a FOR clause of a DISPLAY command evaluated to a negative number.

This number must be a non-negative value.

184

This error may be reported when examining save files created from system dumps. It

is reported when the specified variable is contained in a data page that was not

present at the time that the system dump was taken. (This only applies to save files

that were created from a system dump by CRUNCH.)

Source assign name must include a volume name

Source assign original name and current name must have the

same qualification

This source assign name does not exist

Invalid length specified for DISPLAY

Data page containing variable was not saved