Inspect Manual

Error and Warning Messages
Inspect Manual—429164-006
A-27
185
185
Inspect cannot display all subprocedures entries in the call history because the
program has an unexpected S register value. The stack markers that link
subprocedure calls are addresses relative to the S register. If the program modifies the
S register, Inspect cannot locate subprocedures stack markers.
188
The SSGET system procedure returned the reported error number. See the Guardian
Procedure Errors and Messages Manual for interpretation of the error number.
189
The DISPLAY command specified the SPI-NUM or EMS-NUM clause to display an SPI
buffer whose used length exceeded 4K bytes.
190
An error occurred on a call to the TEXTTOSSID or SSIDTOTEXT procedure. The n-n
values are the error status codes returned by the procedure. For a description of these
codes, see the Guardian Procedure Calls Reference Manual.
191
A STEP OUT SUBPROCS command was issued, but the current location is not within
a subprocedure.
192
A STEP OUT command was issued from a subprocedure, but Inspect cannot step out
of the subprocedure(s) because the program has modified the S register. The stack
Unable to trace subproc(s) due to 'S' register modification
SSGET: error-specification
SPI buffer too large
SSID conversion error n-n
Current location is not a subproc
Unable to step subproc(s) due to 'S' register modification