Inspect Manual

Error and Warning Messages
Inspect Manual—429164-006
A-38
300
300
Inspect was unable to find a value on the data stack that matched a subprocedure's
return address. This could be due to a program’s manipulation of the “S” register
within a subprocedure.
301
The number specified in the command exceeded the allowed range. Segment
numbers must be positive, signed 16-bit numbers.
302
The number specified in the command exceeded the allowed range. The register
pointer value in the RP clause of the RESUME AT command must be in the range 0-7;
numbers in that range are the only legal register values.
303
The maximum number of CPUs in a Tandem system is 16, and they are numbered
from 0-15. The number you specified in the command exceeded the allowed range.
304
The maximum number of processes in a CPU is 256. They are numbered from 0 to
255. The number you specified in the command exceeded the allowed range.
305
This is a warning. Inspect cannot scale a constant to match the pointer type in an
expression.
Unable to traverse subprocedure calls
Segment number maximum is 32767
RP value must be in the range 0-7
A CPU value must be in the range 0-15
A PIN value must be in the range 0-255
Expression is not scaled to match pointer type