Inspect Manual

Error and Warning Messages
Inspect Manual—429164-006
A-44
374
specified to list the correspondence between TNS and TNS/R instructions. It can also
occur when listing TNS instructions given a TNS/R address or listing TNS/R
instructions given a TNS address.
374
This error is reported only for accelerated programs in the rare instance when a
memory access breakpoint, or data breakpoint, has suspended the program in
millicode routine that will alter the flow of program execution. If this is reported, set a
temporary breakpoint at the appropriate location and resume program execution.
375
You cannot use the FB command or AS COMMANDS clause with data (memory
access) breakpoints.
376
You cannot specify READ or WRITE clauses in combination with the CHANGE clause
when setting a data breakpoint.
377
This error is reported if you attempt to select a program that has been added to the
program list as a result of setting a breakpoint in the backup process of a fault-tolerant
process pair. You must wait until the program becomes the primary process.
378
This warning is reported by the FA, FB, FC and FK commands when text insertion or
replacement would cause the command line length to exceed 255 characters.
A memory access breakpoint has left the program at a location
where execution cannot be stepped
Memory access breakpoints not allowed with FB or AS COMMANDS
CHANGE not allowed with READ or WRITE
Cannot select program until it becomes the primary
Insert or replace would have caused command line to exceed
255 characters