Inspect Manual

Error and Warning Messages

Inspect Manual—429164-006

A-46

384

This error is reported if an attempt is made to use the FB command or the AS

COMMANDS clause with breakpoints that were set from low-level Inspect.

385

This warning is reported by the ADD PROGRAM command when a save file for an

accelerated program is added and the file specified with the CODE clause does not

contain accelerator information. When this is the case, you can examine most state

information contained in the save file, with the exception of information that is specified

to accelerator programs.

386

This warning is issued when Inspect reports an event and the backup process of a

fault-tolerant process pair in which a backup breakpoint is set has taken over.

387

This warning is reported for accelerated programs by the ICODE command when it is

necessary for a TNS address to be mapped to a TNS/R address and the end of the

specified range is not a memory-exact point. Most commonly, this occurs when BOTH

is specified to list the correspondence between TNS and TNS/R instructions. It can

also occur when listing TNS instructions given a TNS/R address or listing TNS/R

instructions given a TNS address.

388

This warning is reported by the ICODE command when a source-level location was

specified and the specified range exceeded the bounds of the procedure. In this case,

ICODE is listed until the end of the procedure is reached.

Low-level breakpoints not allowed with FB or AS COMMANDS

Object file file does not contain accelerator information

Backup for program has taken over

Ending location is not a memory-exact point;

listing ends at following memory-exact point

Listing ends at procedure end