Inspect Manual

Error and Warning Messages
Inspect Manual—429164-006
A-49
450
450
This error message is reported when the user enters an ADD PROGRAM command
and attempts to open a snapshot file that contains DLL information. Inspect does not
support the debugging of DLLs. You must use either Visual Inspect or Debug on
TNS/R systems. On TNS/E systems, use either Visual Inspect or Native Inspect.
1003
This error is reported when the ADD PROGRAM command is used to add a TNS/E
process to an Inspect debugging session on a TNS/E system. Inspect can only be
used to debug TNS programs and TNS and TNS/R snapshots on a TNS/E system.
1004
This error is reported when the ADD PROGRAM command is used to add a TNS/E
snapshot to a debugging session on a TNS/E system. Inspect can only be used to
debug TNS programs and TNS and TNS/R snapshots on a TNS/E system.
1005
A command such as the DISPLAY REGISTER BOTH command was entered, and the
current program is a TNS program on a TNS/E system. Inspect will display the TNS
registers as if the DISPLAY REGISTER ALL command was entered.
1006
A command such as the ICODE address BOTH command was entered, and the
current program is a TNS program on a TNS/E system. Inspect will display the TNS
instructions as if the command ICODE address was entered, where address is a
TNS address.
This snapshot file contains dynamic link library information.
Visual Inspect is required.
Process name cpu,pin is a TNS/E process. Visual Inspect or
Native Inspect is required.
This is a snapshot of a TNS/E process. Visual Inspect or
Native Inspect is required.
Inspect cannot display TNS/E registers.
Inspect cannot display TNS/E instructions.