IPX/SPX Configuration and Management Manual

What’s New in This Manual
IPX/SPX Configuration and Management Manual—425731-001
x
New and Changed Information
•
In Section 1, changed the names and locations of some of the NonStop™ IPX/SPX
files that are installed. See item 2 under Task 2: Install and Configure NonStop™
IPX/SPX on page 1-4.
•
Changed the format for LAN and token-ring LIF names from LANxx and TOKxx
format to L0xx. See Section 1, Configuration Quick Start and Managing
NonStop™ IPX/SPX With the Subsystem Control Facility (SCF).
•
Noted in Sections 1 and 3 that you can change the LIF names, but we recommend
you do so only if you understand the system very well.
•
Added the information that applications such as Telserv are able to access
NonStop™ TCP/IP and NonStop™ IPX/SPX at the same time via the socket
interface. See Sockets Interface in Section 2.
•
Indicated that IPXPROTO supports the SPX II NetWare protocol. See IPX Protocol
(IPXPROTO) Process on page 2-5.
•
Clarified the names of the NetWare frame types. See IPX Protocol (IPXPROTO)
Process on page 2-5 and tables referring to these frame types throughout the manual.
•
Updated information on NetWare and NonStop™ IPX/SPX system requirements in
Section 2. See NetWare and NonStop™ System Requirements on page 2-16.
•
Changed the SCF prompt in Section 3 from SCF> to ->.
•
Updated PTrace facility examples and fields in NonStop™ IPX/SPX PTrace
Facility.
•
Added new error messages and an event message in Appendix B, Event Messages
for NonStop™ IPX/SPX and Appendix D, Error Messages for NonStop™ IPX/SPX.