IPX/SPX Configuration and Management Manual

Event Messages for NonStop™ IPX/SPX
IPX/SPX Configuration and Management Manual—425731-001
B-5
1: ZIPX-EVT-PROCESS-AVAIL
ZEMS-TKN-STATE-PREVIOUS
has one of the following values, depending on the previous state of the object:
ZEMS-TKN-CHANGE-REASON
has one of the following values, depending on why the object became available:
Event-Message Text
In the text message:
process name
indicates the name of the IPXPROTO process for which this event is generated.
change reason
indicates why the object changed states.
prev state
indicates the state that the IPXPROTO process was in before this event occurred.
curr state
indicates the state of the IPXPROTO process after this event occurred.
Cause. NonStop™ IPX/SPX issues this message whenever a process becomes
available.
Effect. The process has been created and initialized and is ready for use.
Recovery. None. This is an informational message.
Value Meaning
ZCOM-VAL-SUMSTATE-ABORTING Previous state was
ABORTING.
ZCOM-VAL-SUMSTATE-STARTED Previous state was STARTED.
ZCOM-VAL-SUMSTATE-STOPPED Previous state was STOPPED.
ZCOM-VAL-SUMSTATE-STOPPING Previous state was
STOPPING.
Value Meaning
ZEMS-VAL-OPERATOR-
INITIATED
Action was initiated by an operator.
ZEMS-VAL-UNDERLYING-UP Indicates the object came up because the
underlying object has come up.