IPX/SPX Configuration and Management Manual

Error Messages for NonStop™ IPX/SPX

IPX/SPX Configuration and Management Manual—425731-001

D-4

Object Unavailable

process name

indicates the name of the IPXPROTO process for which this event is generated.

failure cause

indicates the reason for the failure.

underlying obj-name

specifies the name of the underlying object that failed.

symptom string

provides further details on the cause of the failure. Possible values are MEMORY,

NETWORK, or UNKNOWN.

Cause. NonStop™ IPX/SPX issues this message whenever a process becomes

unavailable or a restart operation has failed. This message indicates that the process is

not available for use and specifies the reason. This event occurs after the process either

has been stopped or aborted using SCF, when executing cleanup procedures because of a

fatal error, or when the process cannot initialize.

Effect. The desired process is not available for use.

Recovery. If the process was stopped or aborted using SCF, use the SCF START

command to restart the process.

If the failure was caused by an internal failure, take the appropriate recovery action:

process name Object Unavailable

Cause: failure cause

[ Underlying object: underlying obj-name ]

[ Symptom: symptom string ]

MEMORY The process could not obtain memory during initialization. Possible

causes and recommended actions are:

The QIO monitor (QIOMON) process may not be configured with

enough memory. Increase memory limits by reconfiguring QIO.

The QIOMON process may not be running. Use the QIO subsystem

SCF STATUS MON command to check the status of the QIOMON

process.