IPX/SPX Configuration and Management Manual

Error Messages for NonStop™ IPX/SPX

IPX/SPX Configuration and Management Manual—425731-001

D-9

IPXSPX 00011

obj-name

is the name of the object you specified in an ALTER command.

Cause. The ALTER command failed for one of the following reasons.

•

The SLSA logical interface (LIF) is down, or the LIF is not accessible.

•

The specified processors are not on the access list.

•

The specified IOPORTNAME is incorrect.

Effect. The command is not executed.

Recovery. Verify that the specified IOPORTNAME exists, is configured for QIO, and

is in the correct format. Make sure that the LIF is started with the specified processors

on the access list.

IPXSPX 00012

obj-name

is the name of the object you specified in an ADD command.

error

is either a file-system error or one of the following:

IPXSPX 00011 ALTER obj-name failed due to error = error

IPXSPX 00012 ADD obj-name failed due to error = error

1 Program file error. An error occurred when the IPXMGR process

attempted to start the IPXPROTO process. The problem is related to

the specified CODEFILE. Make sure the specified CODEFILE

exists.

11 Process-name error. An error occurred when the IPXMGR process

attempted to start the IPXPROTO process. The problem is related to

the specified process name. Make sure the process name is in the

correct format and that a process using that name does not already

exist.

51 The specified IOPORTNAME is invalid. Ensure that the

IOPORTNAME is specified in the following form:

LIF-name.filter-protocol. (See Specifying Processes, LIF

Names, and Filter Protocols in SCF Commands on page 3-8.)