IPX/SPX Configuration and Management Manual

Managing NonStop™ IPX/SPX With the Subsystem
Control Facility (SCF)
IPX/SPX Configuration and Management Manual—425731-001
3-22
INFO Command
INFO PROCESS Display Format With DETAIL
Program File Name
displays the fully qualified name of the program object file (that is, the codefile) that
creates this IPXMGR process.
I/O Port Name
displays the IOPORTNAME, which takes the form LIF-name.filter-
protocol.
LIF-name displays the name of the logical interface (LIF). An Ethernet or
token-ring LIF name usually takes the form L0xx.
filter-protocol displays the filter protocol that corresponds to the frame
type of the NetWare LAN.
For more information, see Specifying Processes, LIF Names, and Filter Protocols in
SCF Commands on page 3-8.
Primary CPU
is the number of the processor in which the primary IPXPROTO process is running.
The primary IPXPROTO process always runs in the same processor as the primary
processor for the ServerNet Addressable Controller (SAC).
I/O Port Address
displays
%H8137 if the filter protocol is ipxeth.
%HAA if the filter protocol is ipxsnap.
%HE0 if the filter protocol is ipx8022.
This value is retrieved automatically (there is no equivalent SCF attribute).
-> INFO PROCESS $ZNV2, DETAIL
IPXSPX Detailed Info PROCESS \IDC14.$ZNV2
Program File Name \IDC14.$SYSTEM.ZIPXPRO.IPXPROTO
*I/O Port Name L018 IPX8023
QIO Lib...................N/A
Primary CPU ............ 1 Backup CPU.............0
I/O Port Address ........%H0000 %H00FF I/O Port Type .........802.3
*IPX Max Sockets ........ 50 *QIO Limit (%)..........0
*SPX Max Binds .......... 25 *SPX Max Conn .........300
*SPX Max Resend .......... 65 *SPX Keep Alive Timer ..5