iTP Active Transaction Pages (iTP ATP) Programmer's Guide

Installing and Running ATP
iTP Active Transaction Pages (iTP ATP) Programmer’s Guide—522292-002
2-3
Copy the ATP Software From the Distribution
Medium
4. On the Placement Options screen, click the NonStop Kernel RISC radio button.
Uncheck the box for “Use DSM/SCM to complete installation on host.” Click Next.
5. On the Product Selection screen, highlight ATP as the product you want to install.
Click the ADD button. Click Next.
6. Log on with a userid that is capable of writing to the /usr OSS directory (for
example, super.super) by following the instructions on the Host Information screen.
You can use either the system name or the system IP address to log on. Click Next.
7. On the Host Target screen, you can either accept the default locations for Work and
Backup subvolumes or browse to locations of your choice. Click Next when you are
satisfied with the locations.
8. On the Host File Placement screen, you can either accept the default disk locations
or browse to locations of your choice. Click Next when you are satisfied with the
locations.
9. On the Placement Manifest screen, review the file locations. You can click Back to
go back and change them. When you are satisfied with the locations, click Next.
This step may take a few minutes to complete.
10. On the Placement Complete screen, you can choose the check boxes to view the
release documentation. It is recommended that you review the release
documentation. Click Finish to complete running IPSetup.
Copy the ATP Software From the Distribution Medium
If you are using IPSetup with a product CD, the following procedure is handled
automatically, so ignore these steps and move on to Install the Product and Example
Files on page 2-4 after IPSetup completes.
If you are not using IPSetup, follow these steps to copy the ATP software from the
distribution medium:
1. Copy the product files to $ISV.ZATP (where ISV is the name of your installation
subvolume).
If you will also be installing a new XML for ATP, be sure to copy the product files
for it.
2. On the Compaq NonStop system, log on as SUPER.SUPER, go to $ISV.ZATP, and
unpax the product file using the TACL macro COPYOSS:
TACL> LOGON SUPER.SUPER
TACL> VOLUME $ISV.ZATP
TACL> RUN COPYOSS T0345PAX
TACL> RUN COPYOSS T1242PAX (if you’re installing XML for ATP)
This places the contents of T0345PAX into the directory /usr/tandem/atp and,
if you are installing XML for ATP, places the contents of T1242PAX into the
directory /usr/tandem/atp/pkgs.