iTP Secure WebServer Operator Messages Manual

iTP Secure WebServer Operator Messages Manual—429507-002
1-1
1 WEBSERV Messages
This section describes the operator messages generated by the iTP Secure
WebServer subsystem. The subsystem ID displayed by these messages includes
WEBSERV as the subsystem name.
Tabl e 1-1 lists the iTP Secure WebServer Components that report operator messages:
Events 1 through 999:
WebServer (httpd process) Messages
(Identifier: httpd)
29
Cause. The configuration file (httpd.config) contains one or more of the following
obsolete directives:
•
Port
•
SSLPort
•
ServerAddress
•
ServerName
•
SSLName
Effect. The iTP Secure WebServer environment does not start.
Recovery. Check the configuration file (httpd.config) for any of these directives. If
Port, ServerAddress, and ServerName are used, use the Accept directive instead. If
Note. Negative-numbered messages are common to most subsystems. If you receive a
negative-numbered message, refer to the Operator Messages Manual .
Table 1-1. iTP Secure WebServer Components That Report Operator Messages
Component
Description
Starts on:
ID Event Numbers
WebServer (httpd process) 1-1 httpd Less than 1000.
Distributor process 1-33 dist Between 2000 and 2999.
Common Gateway Interface (CGI
Server Processes and CGI Library)
1-50 cgi Between 3000 and 3999.
WebSafe2 1-61 wsf Between 6000 and 7000.
Servlet Server Class (SSC) 1-67 ssc Between 7000 and 8000
and contain the identifier ssc.
(#29) incompatibility mode for Port, ServerAddress, and/or
ServerName directive