iTP Secure WebServer Operator Messages Manual

WEBSERV Messages
iTP Secure WebServer Operator Messages Manual—429507-002
1-3
Events 1 through 999: WebServer (httpd process)
Messages (Identifier: httpd)
195
directive-name
is the name of the configuration directive that caused the error.
host-name
is the invalid host name or address.
Cause. An error occurred when the httpd process tried to obtain a host name.
Effect. The iTP Secure WebServer environment does not start.
Recovery. One possibility is that the host name or IP address is misspelled in the
configuration file (httpd.config). If this is the cause, correct the misspelling and restart
the iTP Secure WebServer.
If the host name and IP address are spelled correctly, ensure that the host name and
IP address are registered in the DNS database file. If the host name is not registered,
change the configuration file (httpd.config) to reflect the server IP address. Make sure
both hostname and hostid are initialized in the TCP/IP process, which is the default
setup for the DEFINE =TCPIP^PROCESS^NAME parameter. Delete the
DEFINE=TCPIP^HOST^FILE parameter when DNS is used to resolve IP addresses.
After correcting the problems, restart the iTP Secure WebServer.
For information about configuration directives, see the iTP Secure WebServer System
Administrator’s Guide .
196
directive-name
is the name of the configuration directive that caused the error.
host-name
is the invalid host name or address.
Cause. The host name resolved to more than one IP address.
Effect. The iTP Secure WebServer environment does not start.
Effect. This situation is very unlikely to occur. If it occurs, check DNS to ensure that
the host name in question corresponds to the correct address.
(#195) directive-name directive: invalid hostname or address
( host-name )
(#196) directive-name directive: hostname resolves to more
than one IP address ( host-name )