iTP Secure WebServer Operator Messages Manual

WEBSERV Messages
iTP Secure WebServer Operator Messages Manual—429507-002
1-13
Events 1 through 999: WebServer (httpd process)
Messages (Identifier: httpd)
Effect. The iTP Secure WebServer environment does not start.
Recovery. Ensure that your current working directory exists. If the directory does
exist, contact your service provider and provide the following information:
•
The message number
•
The configuration file (httpd.config)
•
Log files
545
port-num
is the port number that could not be verified for the Accept or
AcceptSecureTransport command.
Cause. While attempting to restart the httpd process, a SERVERCLASS_SEND error
to the Distributor process occurred. Therefore, the httpd process could not confirm the
specified port number to use for its connection. This message appears in addition to
message 556.
Effect. The httpd process cannot communicate with the Distributor process using this
port , but continues to run.
Recovery. The most likely cause is that the port number is already in use. Use SCF to
query TCP/IP about the port numbers in use. If the port number is already in use, you
will need to change the configuration file (httpd.config) so that it specifies a unique port
number.
546
Cause. The reply buffer from the Distributor process has a content value that does not
match any expected value. This message usually signifies a port error in the Distributor
process.
Effect. The httpd process cannot verify the port number used by the Distributor
process.
Recovery. Informational message only; no corrective action is needed.
(#545) could not verify if distributor is using port port-num
(#546) did not get expected message from distributor