iTP Secure WebServer Operator Messages Manual

WEBSERV Messages
iTP Secure WebServer Operator Messages Manual—429507-002
1-25
Events 1 through 999: WebServer (httpd process)
Messages (Identifier: httpd)
required, stop the iTP Secure WebServer environment and restart the iTP Secure
WebServer.
571
ferror-code
is a code for the file-system error that occurred. See the Guardian Procedure
Errors and Messages Manual for explanations of the file-system error codes.
Cause. The iTP Secure WebServer could not open $RECEIVE because of an error.
Refer to the error reported in the message for more details about the cause.
Effect. The httpd process exits.
Recovery. Consult the Guardian Procedure Errors and Messages Manual for error
information. Take any recommended measures to correct the file-system error. If
required, stop the iTP Secure WebServer environment and restart the iTP Secure
WebServer.
573
Cause. The system administrator did not configure the TANDEM_RECEIVE_DEPTH
environment variable.
Effect. The iTP Secure WebServer defaults to a receive depth of 1.
Recovery. If the iTP Secure WebServer requires a larger receive depth value, the
system administrator must stop the iTP Secure WebServer, modify the configuration
file (httpd.config) to include the TANDEM_RECEIVE_DEPTH environment variable
with the desired receive depth value and restart the iTP Secure WebServer. See the
iTP Secure WebServer System Administrator’s Guide for information about configuring
the TANDEM_RECEIVE_DEPTH environment variable.
574
number
is the invalid value specified for TANDEM_RECEIVE_DEPTH.
(#571) can not open $RECEIVE ferror-code
(#573) ENV TANDEM_RECEIVE_DEPTH not specified, defaulting
to 1
(#574) ENV TANDEM_RECEIVE_DEPTH= number not valid, defaulting
to 1