iTP Secure WebServer Operator Messages Manual

WEBSERV Messages
iTP Secure WebServer Operator Messages Manual—429507-002
1-39
Events 2000 through 2999: Distributor Process
Messages (Identifier: dist)
Recovery. Contact your service provider, and provide all relevant information as
described in the beginning of Events 2000 through 2999: Distributor Process
Messages (Identifier: dist) on page 1-33.
2012
distributor-build-stamp
is the timestamp of when the Distributor process started.
Cause. This is the Distributor process startup message.
Effect. Informational message only.
Recovery. Informational message only; no corrective action is needed.
2013
socket-error
is an error code returned by the TCP/IP socket function. See the TCP/IP and
IPX/SPX Programming Manual for explanations of socket errors.
Cause. The Distributor process attempted to obtain a new control socket and failed.
Refer to the error reported in the message for more details about the cause.
Effect. The Distributor process exits.
Recovery. Contact your service provider, and provide all relevant information as
described in the beginning of Events 2000 through 2999: Distributor Process
Messages (Identifier: dist) on page 1-33.
2014
ferror-code
is a code for the file-system error that occurred. See the Guardian Procedure
Errors and Messages Manual
for explanations of the file-system error codes.
Cause. An error occurred when the Distributor process attempted to open $RECEIVE.
Refer to the error reported in the message for more details about the cause.
Effect. The Distributor process exits.
(#2012) distributor started: built distributor-build-stamp
(#2013) socket_nw error: could not get control socket
errno= socket-error
(#2014) FILE_OPEN failed ferror-code