iTP Secure WebServer Operator Messages Manual

ManualsBrandsHP ManualsServerHP NonStop G-Series

WEBSERV Messages

iTP Secure WebServer Operator Messages Manual—429507-002

1-62

Events 6000 through 6999: WebSafe2 Messages

(Identifier: wsf)

Recovery. Replace the cipher specification in the AcceptSecureTransport directive

with a supported value as listed in the

iTP Secure WebServer System Administrator’s

Guide

For information about the AcceptSecureTransport directive, see the

iTP Secure

WebServer System Administrator’s Guide

6003

perror-code

is a code for the PATHMON error that occurred. See the

NonStop TS/MP and

Pathway Management Programming Messages Manual

for explanations of the

PATHMON error codes.

ferror-code

is a code for the file-system error that occurred. See the

Guardian Procedure

Errors and Messages Manual

for explanations of the file-system error codes.

Cause. A Pathsend request to the WebSafe2 Interface Driver (WID) server has failed.

Effect. The request aborts.

Recovery. More information can be found by examining the PATHMON errors and

file-system errors. Consult the

NonStop TS/MP and Pathway Management

Programming Messages Manual

and the

Guardian Procedure Errors and Messages

Manual

for recovery information based on the error codes reported in the message.

6005

error-num

is a code for the RSA BSafe library error.

Cause. The decryption routine failed while trying to decrypt a master key.

Effect. The request aborts.

Recovery. Examine the WID trace files (which log communications between the

WebSafe2 unit and the WID) and the WID error log to help determine the cause.

Contact your service provider, and provide these files and the additional information

described in the beginning of Events 6000 through 6999: WebSafe2 Messages

(Identifier: wsf) on page 1-61.

(#6003) SERVERCLASS_SEND_ to WID failed.

Pathmon error:

perror-code

, file sys error:

ferror-code

(#6005) Decrypt master session key failed using KEK. error

error-num