iTP Secure WebServer Operator Messages Manual

WEBSERV Messages
iTP Secure WebServer Operator Messages Manual—429507-002
1-67
Events 7000 through 7999: Servlet Server Class
(SSC) Messages (Identifier: ssc)
Effect. The Secure Sockets Layer (SSL) handshake fails.
Recovery. Informational message only; no corrective action is required.
6021
Cause. The iTP Secure WebServer was configured with a WebSafe2 unit with a
version prior to 2.6.11 that does not support SSLV3 and cipher DES-CBC3-MD5.
Effect. The DES-CBC3-MD5 cipher is disabled.
Recovery. If AcceptSecureTransport -ciphers is specified, use the ciphers specified
for WebSafe prior to 2.6.11 as described in the iTP Secure WebServer System
Administrator’s Guide .
6023
Cause. The WebSafe Interface Driver (WID) returned an error when the iTP Secure
WebServer sent a request to the WID to obtain necessary information for the
ServerKeyExchange message.
Effect. The connection is aborted.
Recovery. Refer to the widerror.log and widtrace.log. If the Atalla WebSafe2
firmware is incompatible, the widerror.log indicates that the firmware needs to be
upgraded.
Events 7000 through 7999:
Servlet Server Class (SSC) Messages
(Identifier: ssc)
7001
Cause. The Servlet Server Class has been started.
Effect. None.
(#6021) Cannot make SSLV3 connection with this cert. Only
SSLV2 will be supported. SSLV2 cipher DES-CBC3-MD-5 will be
disabled.
(#6023) Unable to get server keyexchange information. WID
error <error_num> <error detail>
(#7001) Servlet Server Class started. Version Procedure =
T1222V10_xxxx_xx.