iTP Secure WebServer System Administrator's Guide (iTPWebSvr 5.1+)

Integrating the WebSafe2 Internet Security
Processor (WISP)
iTP Secure WebServer System Administrator’s Guide—522659-001
5-19
Using Appropriate WebSafe2 Internet Security
Processor (WISP) Firmware
If you are using the SSL 3.0 protocol, observe the following guidelines:
Using Appropriate WebSafe2 Internet Security Processor (WISP)
Firmware
Make sure your WISPs are using firmware version 2611 or later. To use 1024 bit key-
length certificates, you must run Atalla WISP firmware version 2.761.
Installing the Latest WebSafe2 Interface Driver (WID) Software
Install the latest WID software as described on Installing the WebSafe2 Interface Driver
(WID) on page 5-7.
Keys Were Generated With:
keyadmin
Version:
WebSafe2
Internet
Security
Processor
(WISP)
Firmware
Version:
Certificate
Configured With
WebSafe2
Internet Security
Processor (WISP)
Firmware
Version: Can You Use the Certificate?
Earlier than
iTP Secure
WebServer 3.3
Any version Any version No; you must use the SSL 2.0
protocol or generate new keys
Any version 250 or later 2.4 or earlier No; the APKB format is
incompatible
2
iTP Secure
WebServer 3.3
250 or later 2611 or later Yes
iTP Secure
WebServer 3.3
Any Earlier than 2611 No; the APKB format is
incompatible (the new key type
cannot be used with older
commands)
3
iTP Secure
WebServer 3.3
2.4 or earlier 2611 or later Yes, after key conversion is done
1
1 For key conversions, contact Atalla
2 Refer to other combinations in this table that allow you to obtain certificates you can use
3 Refer to other combinations in this table that allow you to use the certificate you previously obtained