iTP Secure WebServer System Administrator's Guide (iTPWebSvr 5.1+)

Installing the iTP Secure WebServer
iTP Secure WebServer System Administrator’s Guide—522659-001
2-5
Event Management Service (EMS) Template
Installation
You Can No Longer Use Restarth
Because the new product architecture no longer has a distributor working as a buffer
zone between the incoming connection requests and the httpd servers, new servers
cannot successfully bind to a local port unless the older httpd servers cease their
operations. Therefore the -restarth option is no longer supported if you are using
Parallel Library TCP/IP.
4. If you do not have Domain Name Server (DNS) running on your network, configure
and run DNS. You start DNS when you start TCP/IP. The out-of-box start-up
requires that the host name be fully qualified to match the DNS entry. The host ID
must be configured using the IP address defined for host name.
5. When you configure DNS, you must modify the file $SYSTEM.ZTCPIP.RESCONF
to point to the DNS name server you are using. For information about starting DNS,
refer to the TCP/IP Configuration and Management Manual.
6. For security, you should add a super ID (for example, super.webmastr) configured
for the OSS environment, and you should use this super ID instead of super.super
when installing the software.
7. Log on to the newly created super ID before installing the iTP Secure WebServer
software:
TACL> LOGON super.webmastr
Event Management Service (EMS) Template
Installation
Before you install the iTP Secure WebServer, you should install the EMS templates.
When the templates are installed, each event reported by the iTP Secure WebServer
appears in EMS displays and logs using the subsystem identifier
TANDEM.WEBSERV.version and an event number that identifies the error or other
event. See Appendix B, Error Messages
for more information and examples.
If you do not install the EMS templates, all event messages from the iTP Secure
WebServer appear as if generated by OSS. Each message has the subsystem identifier
TANDEM.OSS.version and an event number that represents not the event itself but a
severity ranking.
Follow this procedure after you unpax the iTP Secure WebServer pax file (as described
in Installing and Configuring the iTP Secure WebServer
on page 2-6):
To install a new set of EMS templates:
1. Log on using the super ID:
super.super
2. Rename the files $system.zweb.newres and $system.zweb.newnres. (For example,
you could call them newres1 and newnres1).