iTP Secure WebServer System Administrator's Guide (iTPWebSvr 6.0+)

Integrating the WebSafe2 Internet Security
Processor (WISP)
iTP Secure WebServer System Administrator’s Guide—523346-002
5-19
Using Earlier Version Keys and Certificates
If you are using the SSL 3.0 protocol, observe the following guidelines:
iTP Secure
WebServer 3.3
Any Earlier than 2611 No; the APKB format is
incompatible (the new
key type cannot be used
with older commands)
3
iTP Secure
WebServer 3.3
2.4 or earlier 2611 or later Yes, after key conversion
is done
1
1 For key conversions, contact Atalla
2 Refer to other combinations in this table that allow you to obtain certificates you can use
3 Refer to other combinations in this table that allow you to use the certificate you previously obtained
Keys Were Generated With:
keyadmin
Version:
WebSafe2 Internet
Security Processor
(WISP) Firmware
Version:
Certificate
Configured With
WebSafe2 Internet
Security Processor
(WISP) Firmware
Version:
Can You Use the
Certificate?
Earlier than iTP
Secure
WebServer 3.3
Any version Any version No; you must use the
SSL 2.0 protocol or
generate new keys
Any version 250 or later 2.4 or earlier No; the APKB format is
incompatible
2
iTP Secure
WebServer 3.3
250 or later 2611 or later Yes
iTP Secure
WebServer 3.3
Any Earlier than 2611 No; the APKB format is
incompatible (the new
key type cannot be used
with older commands)
3
iTP Secure
WebServer 3.3
2.4 or earlier 2611 or later Yes, after key conversion
is done
1
1 For key conversions, contact Atalla
2 Refer to other combinations in this table that allow you to obtain certificates you can use
3 Refer to other combinations in this table that allow you to use the certificate you previously obtained
Keys Were Generated With:
keyadmin
Version
WebSafe2 Internet
Security Processor
(WISP) Firmware
Version
Certificate
Configured With
WebSafe2 Internet
Security Processor
(WISP) Firmware
Version
Can You Use the
Certificate?