iTP Secure WebServer System Administrator's Guide (iTPWebSvr 6.0+)

Configuration Directives
iTP Secure WebServer System Administrator’s Guide—523346-002
A-2
Accept
Directives that were supported in earlier releases of the iTP Secure WebServer, and
that have been superseded by new directives are listed in Tabl e A-1:
Accept
Syntax
Accept -transport transport-name [-address server-addr] [-name
server-name] [-port port-num]
Description
Use the Accept directive to configure the iTP Secure WebServer (server-name in
the above example) to accept HTTP connections on one or more specified transports
and ports.
The Accept directive takes the following arguments:
-transport transport-name
The transport name (transport-name) is a TCP/IP process name in OSS format
(that is, preceded by /G/).
One transport-name is required.™
-address server-addr
Use the -address argument to configure the server to accept connections on a
specified address (server-addr). The address you specify can be either a
numeric IP address or a valid name or alias registered with the Domain Name
Service (DNS). If no -address argument is specified, the iTP Secure WebServer
accepts connections on all IP addresses currently valid for the iTP Secure
WebServer machine.
Table A-1. Directives That Have Been Replaced
Previously Supported Directive Replaced by New Directive(s)
Port Accept
on page A-2
ServerAddress Accept
on page A-2
AcceptSecureTransport
on page A-5
ServerName Accept
on page A-2
AcceptSecureTransport
on page A-5
SSLName AcceptSecureTransport
on page A-5
SSLPort AcceptSecureTransport
on page A-5
Transport Accept
on page A-2
AcceptSecureTransport on page A-5
WebSafe AcceptSecureTransport
on page A-5