iTP Secure WebServer System Administrator's Guide (iTPWebSvr 6.0+)
Installing the iTP Secure WebServer
iTP Secure WebServer System Administrator’s Guide—523346-002
2-7
Installing and Configuring the iTP Secure
WebServer
The script displays the number of errors and warnings and terminates on an error. If an
error occurs, you can check the files LWEBDDL, LWEBTMPL, LTEMPLI, and LCOUP for
more information.
If the iTP Secure WebServer is already running when you install the templates, the
change in the presentation of event messages takes effect immediately; you need not
restart the server.
Installing and Configuring the iTP Secure
WebServer
When you install the iTP Secure WebServer, you also install:
•
The iTP Secure WebServer Administration Server, which you may use later to do
the following:
°
Modify configuration files
°
Start, restart, and stop the server environment
°
Display event messages.
•
Secure Transport.
•
The WebSafe2 Internet Security Processor (WISP) if a configuration file for that
device is present.
•
The Resource Locator Service (RLS) if you have previously built the file
rmt.pway.
Use the following procedure to install the iTP Secure WebServer and give it a basic
configuration that you can use for testing. You can make custom changes to the
configuration file later, but the basic configuration allows you to start the server and test
it (if you made all the preparations described earlier).
The procedure for installing the software depends on the distribution medium for the
product. Check the Readme.txt file if you have received the software on a CD. Check
the softdoc before you install the product. The following installation instructions are
correct as of the time this manual was published; however, the Readme.txt file or
softdoc supersedes the information here.
Before You Begin the Installation
•
Review the readme file on the product CD to make sure you have the correct
version for all products installed or to be installed on your system.
•
Make sure your site meets the minimum hardware and software requirements, as
indicated in the IPSetup User's Guide on the product CD.
•
Make sure you know the directory path in which to install your iTP Secure
WebServer. (The default install directory is /usr/tandem/webserver/.)