iTP Secure WebServer System Administrator's Guide (Version 7.0)

Integrating the WebSafe2 Internet Security
Processor (WISP)
iTP Secure WebServer System Administrator’s Guide—523346-012
5-20
Using Earlier Version Keys and Certificates
If you are using the SSL 3.0 protocol, observe these guidelines:
iTP Secure
WebServer 3.3
Any Earlier than 2611 No; the APKB format is
incompatible (the new
key type cannot be used
with older commands)
3
iTP Secure
WebServer 3.3
2.4 or earlier 2611 or later Yes, after key conversion
is done
1
1 For key conversions, contact Atalla
2 See other combinations in this table that allow you to obtain certificates you can use
3 See other combinations in this table that allow you to use the certificate you previously obtained
Keys Were Generated With:
keyadmin
Version
WebSafe2 Internet
Security Processor
(WISP) Firmware
Version:
Certificate
Configured With
WebSafe2 Internet
Security Processor
(WISP) Firmware
Version:
Can You Use the
Certificate?
Earlier than iTP
Secure
WebServer 3.3
Any version Any version No; you must use the
SSL 2.0 protocol or
generate new keys
Any version 250 or later 2.4 or earlier No; the APKB format is
incompatible
2
iTP Secure
WebServer 3.3
250 or later 2611 or later Yes
iTP Secure
WebServer 3.3
Any Earlier than 2611 No; the APKB format is
incompatible (the new
key type cannot be used
with older commands)
3
iTP Secure
WebServer 3.3
2.4 or earlier 2611 or later Yes, after key conversion
is done
1
1 For key conversions, contact Atalla
2 See other combinations in this table that allow you to obtain certificates you can use
3 See other combinations in this table that allow you to use the certificate you previously obtained
Keys Were Generated
keyadmin
Version
WebSafe2 Internet
Security Processor
(WISP) Firmware
Version
Certificate
Configured With
WebSafe2 Internet
Security Processor
(WISP) Firmware
Version
Can You Use the
Certificate? (continued)