iTP Secure WebServer System Administrator's Guide (Version 7.0)

Configuring the iTP Secure WebServer
iTP Secure WebServer System Administrator’s Guide—523346-012
7-61
The WebSafe2 Configuration File
The WebSafe2 Configuration File
This section explains the contents of httpd.websafe.config and describes how to
set parameters in this configuration file. Example 7-6 shows the contents of a sample
httpd.websafe.config file. Note that $root is defined in the file httpd.config.
Example 7-5. Sample WID Configuration File
# filename: wid.config.sample
# blank lines and lines starting with # are ignored
# address of WebSafe Atalla boxes, maximum of 16
# optional TCP/IP process name after IP address
# just add lines with ip = ip address for more Atalla
# boxes
ip = 172.16.10.11 $ZTC9
ip = 172.16.11.13 $ZTC9
# TCP/IP timeout value to the Atalla boxes in 0.01 seconds
# if not set, the default is 500
timeout = 300
# filename for storing certificate and key information
# this entry is required
keyfile = /usr/tandem/webserver/conf/wid.keyfile
# Atalla websafe box highest SSL version supported
# optional
# SSL3 for Atalla websafe boxes 2611 and above with SSL3 support
# SSL2 for Atalla websafe boxes prior to 2611
version = SSL3
# directory to write temporary wid files
# if not set, the default is /tmp
#logdir = /usr/tandem/webserver/logs
# if tracefile is set, all communication to and from
# Atalla boxes is logged
# optional and should be set only if problem arises
# tracefile = /usr/tandem/webserver/logs/widtrace.log
# if errorfile is set, wid errors are logged to this file
# optional but should be set to log errors
errorfile = /usr/tandem/webserver/logs/widerror.log
Note. WISP is compatible only with systems running on G-series RVUs.