iTP Secure WebServer System Administrator's Guide (Version 7.0)

Managing the iTP Secure WebServer From Your
Browser
iTP Secure WebServer System Administrator’s Guide—523346-012
12-17
iTP WebServer Statistics
•
Click Status to get the status of the process for which instrumentation is running.
•
Click Stop to stop the instrumentation.
However, the Start, Status, and Stop buttons will be enabled only when you select at
least one of the httpd processes.
What You Do: Select httpd Process
Select the process for which instrumentation is to be started or stopped and then click
Start or Stop as needed. To select all httpd processes, select the ALL check box. You
can reset the selected processes by clicking the Reset button.
When you click Start, a message is displayed to indicate that the instrumentation for
the selected process is started. If the instrumentation for the selected process has
already been running, a message is displayed to indicate the same.
After starting the instrumentation, click the Status button to collect the statistics. If the
instrumentation for one or more selected processes has not been started when you
click the Status button, a message will be displayed prompting you to start the
instrumentation for those processes.
If the available storage memory is not enough, or the memory arena is corrupted, or
any httpd process terminates, a message will be displayed to indicate the same. If the
admin server restarts, the error message “Admin restarted. Click on Refresh button of
browser or click on Status button at the bottom left corner.” will be displayed.
What You See: Select Parameters
After you select the processes and click the Status button, Parameter selection page
will be displayed with User Parameters and Development Parameters frames along
with the check boxes with each parameter to be selected, a disabled Status button and
an enabled Home button. Initially, the check boxes under the Development Parameters
would be disabled.
What You Do: Select Parameters
Select the required parameters. You can also select all user parameters by selecting
the check box ALL. The Status button will be enabled only when you select atleast one
of the parameters. The development parameters will be enabled only when you select
the Enable Development Parameters check box.
Select the desired parameters and click the Submit button to view the values for the
selected parameters. Click the Home button to go back to the httpd process selection
page. If the admin server restarts, the error message “Admin restarted. Click on
Note. You can collect statistics only for WebServer version ABV or later. If the version is
different, when you click Start or Stop, the message “Instrumentation is supported for iTP
WebServer version ABV or later. Check the version of WebServer.” will be displayed in the
message window.