iTP Secure WebServer System Administrator's Guide (Version 7.0)

iTP Secure WebServer System Administrator’s Guide—523346-012
2-1
2
Installing the iTP Secure WebServer
This section describes what you need to do to prepare your NonStop system to run the
iTP Secure WebServer and explains how to install and configure it. It also provides a
test procedure that you can use to verify configuration and to perform server testing.
Topics discussed in this section include:
•
iTP Secure WebServer System Requirements
•
Preparing Your System for the iTP Secure WebServer on page 2-3
•
Event Management Service (EMS) Template Installation on page 2-6
•
Installing and Configuring the iTP Secure WebServer on page 2-7
•
Verifying the Configuration on page 2-18
•
The Ninety-Day Test Certificate on page 2-21
•
Test-Starting the Administration Server and the iTP Secure WebServer on
page 2-21
•
If You Plan to Use SSL or PCT Encryption on page 2-22
•
If You Plan to Use WebSafe2 Encryption on page 2-22
•
If You Are Using the Nonsecure Version on page 2-22
iTP Secure WebServer System Requirements
The iTP Secure WebServer runs on a variety of NonStop systems and is supported by
standard NonStop subsystems and local area network (LAN) controllers.
Supported NonStop Systems
The iTP Secure WebServer supports these NonStop systems:
•
K-series
•
S-series
•
CLX/R series
•
All OSS-supported systems
•
NS-series (Integrity servers and BladeSystem servers)