LAN Configuration and Management Manual

SCF Commands for the SLSA Subsystem
LAN Configuration and Management Manual—520469-012
4-52
INFO PIF Command
The display for the INFO PIF command with the OBEYFORM option for ATM3SAs is:
INFO PIF DETAIL Display for an E4SA
The display for the INFO PIF command with the DETAIL option is:
Hardware MAC Address
indicates the default MAC address of the specified PIF.
Interface Speed
indicates the maximum speed of the network interface.
Max Frame Size
indicates the maximum frame size that the adapter can handle.
Min Frame Size
indicates the minimum size frame that the adapter can handle.
NodeMACAddress
indicates the primary MAC address used by this node for all transmitted and
received frames. If the node MAC address is not supplied, the default MAC
address from the SEEROM on the adapter is used (that is, the hardware MAC
address). The high-order bit must be 0 and the next highest bit must be 1 for a
locally administered address.
PIF Type
indicates the type of network interface.
-> INFO PIF $ZZLAN.ATM1.0.A.OBEYFORM
ALTER PIF $ZZLAN.A0253.0.A &
,DATAFORWARDCOUNT 2 &
,DATAFORWARDTIME 1 &
,EMSVERBOSE OFF
1>INFO PIF $ZZLAN.E0153.0.A , DETAIL
SLSA Detailed Info PIF \SYS.$ZZLAN.E0153.0.A
Hardware MAC Address.... 08:00:8E:00:78:32
Interface Speed......... 10Mbit/sec
Max Frame Size.......... 1514
Min Frame Size.......... 60
*NodeMACAddress.......... 08:00:8E:00:78:32
PIF Type................ Ethernet