LAN Configuration and Management Manual

SCF Commands for the SLSA Subsystem
LAN Configuration and Management Manual—520469-012
4-56
INFO PIF Command
INFO PIF DETAIL Display for a GESA
The display format for INFO PIF with DETAIL selected for GESAs is:
Hardware MAC Address
indicates the default MAC address from the SEEROM on the adapter.
Interface Speed
indicates the maximum speed of the network interface.
Max Frame Size
indicates the maximum frame size that the adapter can handle. This display shows
a setting for jumbo frames.
Min Frame Size
indicates the minimum frame size that the adapter can handle.
NodeMACAddress
indicates the primary MAC address used by this node for all transmitted and
received frames. If the node MAC address is not supplied, the default MAC
address from the SEEROM on the adapter is used (that is, the hardware MAC
address). The high-order bit must be 0 and the next highest bit must be 1 for a
locally administered address.
PIF Type
indicates the type of network interface.
Autonegotiation
indicates whether the sender and receiver can negotiate a line speed. If
Autonegotiation is ON, you may not alter the duplex value or line speed value.
1>INFO PIF $ZZLAN.G0253.0.A , DETAIL
SLSA Detailed Info PIF \SYS.$ZZLAN.G0253.0.A
Hardware MAC Address.... 08:00:8E:00:78:B0
Interface Speed......... 1000 Mbit/sec
Max Frame Size.......... 9014
Min Frame Size.......... 60
*NodeMACAddress.......... 08:00:8E:00:78:B0
PIF Type................ Ethernet
GESA Specific Info
*AutoNegotiation..........ON
*Duplex ..................
*LineSpeed ...............
*JumboFrame ..............ON
Interface Type ..........Copper