LAN Configuration and Management Manual

SCF Commands for the SLSA Subsystem
LAN Configuration and Management Manual—520469-012
4-57
INFO PIF Command
Duplex
indicates full-duplex or half-duplex operations. The value is not shown, because
Autonegotiation is ON.
Linespeed
indicates the line speed. Value not shown, because Autonegotiation is ON.
JumboFrame
indicates the choice of normal or jumbo frames (activated by the Maximum
Transmission Unit (MTU) setting in your Parallel Library TCP/IP or NonStop
TCP/IPv6 configuration).
Interface Type
indicates the physical cabling: copper or short-haul fiber (SX).
INFO PIF DETAIL Display for a G4SA
The display format for INFO PIF with DETAIL selected for G4SAs is:
Hardware MAC Address
indicates the default MAC address from the SEEROM on the adapter.
Interface Speed
indicates the maximum speed of the network interface.
Max Frame Size
indicates the maximum frame size that the adapter can handle.
Note. Parallel Library TCP/IP is not supported on Integrity NonStop NS-series servers.
1>INFO PIF $ZZLAN.G11123.0.A , DETAIL
SLSA Detailed Info PIF \SYS.$ZZLAN.G11123.0.A
Hardware MAC Address.... 00:04:76:DC:0B:51
Interface Speed......... 1000 Mbit/sec
Max Frame Size.......... 1514
Min Frame Size.......... 60
*NodeMACAddress.......... 00:04:76:DC:0B:51
PIF Type................ Ethernet
G4SA Specific Info
*AutoNegotiation..........ON
*Duplex ..................
*LineSpeed ...............
*JumboFrame ..............OFF
*Interface ..............AUTODETECT