LAN Configuration and Management Manual

SCF Commands for the SLSA Subsystem
LAN Configuration and Management Manual—520469-012
4-59
INFO PIF Command
INFO PIF DETAIL Display for a TRSA
The display for the INFO PIF command with the DETAIL option for TRSAs is:
Hardware MAC Address
indicates the default MAC address from the SEEROM on the adapter.
Interface Speed
indicates the maximum speed of the network interface.
Max Frame Size
indicates the maximum frame size that the adapter can handle.
Min Frame Size
indicates the minimum frame size that the adapter can handle.
NodeMACAddress
indicates the primary MAC address used by this node for all transmitted and
received frames. If the node MAC address is not supplied, the default MAC
address from the SEEROM on the adapter is used (that is, the hardware MAC
address). The high-order bit must be 0 and the next highest bit must be 1 for a
locally administered address.
PIF Type
indicates the type of network interface.
ActiveMonitor
specifies whether the adapter participates in the monitor function of token-ring
LANs. ON specifies that the node is either a standby monitor or an active monitor
on the ring. The token-ring chipset handles the monitor and contention protocol,
and switches from standby monitor to active monitor if required. All token-ring
LANs need an active monitor. The default value is OFF.
1>SCF INFO PIF \SYS.$ZZLAN.T0154.0.A, DETAIL
SLSA Detailed Info PIF \SYS.$ZZLAN.T0154.0.A
Hardware MAC Address.... 08:00:8E:00:DD:FB
Interface Speed......... N/A
Max Frame Size.......... 17832
Min Frame Size.......... 32
*NodeMACAddress.......... 08:00:8E:00:DD:FB
PIF Type................ Token Ring
TRSA Specific Info
*ActiveMonitor......... OFF
*EarlyTokenRelease..... OFF
*MaxSessions........... 2000
*RingSpeed............. 16 Mb